EMERGENCY
CRANK RADIO/FLASHLIGHT
98319
SET up AND OpERATING INSTRuCTIONS
®
Distributed exclusively by Harbor Freight Tools .
3491 Mission Oaks Blvd., Camarillo, CA 93011
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANuAL.
©
®
Copyright 2008 by Harbor Freight Tools . All rights reserved. No portion of this manual or any artwork
contained herein may be reproduced in any shape or form without the express written consent of
Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product described herein. Tools required for
assembly and service may not be included.
For technical questions or replacement parts, please call 1-800-444-3353.
3. personal safety
5. Battery tool use and care
a.Stay alert, watch what you are do-
ing and use common sense when
operating this product. Do not use
this product while you are tired or
under the influence of drugs, alco-
hol or medication.
a.Recharge only with the Crank
Handle (3).
b.under abusive conditions, liquid
may be ejected from the battery;
avoid contact. If contact acciden-
tally occurs, flush with water. If
liquid contacts eyes, additionally
seek medical help. Liquid ejected
from the battery may cause irritation
or burns.
4. product use and care
a.Do not force this product. use the
correct product for your applica-
tion. The correct product will do the
job better and safer at the rate for
which it was designed.
6. Service
a.Have this product serviced by a
qualified repair person using only
identical replacement parts. This
will ensure that the safety of the unit
is maintained.
b.Turn the power Switch (13) to its
“OFF” position before making any
adjustments, changing acces-
sories, or storing the unit. Such
preventive safety measures reduce
the risk of starting the product acci-
dentally.
Additional precautions
c.Store this product out of the reach
of children and do not allow per-
sons unfamiliar with the product or
these instructions to operate the
unit.
1. Maintain labels and nameplates on
the product. These carry important
safety information. If unreadable or
missing, contact Harbor Freight Tools
for a replacement.
d.Maintain this product. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
product’s operation. If damaged,
have the product repaired before
use. Many accidents are caused by
poorly maintained products.
2. Avoid unintentional starting. Prepare
to begin work before turning on the
product.
3. Do not leave the tool unattended
when its Power Switch (13) is on.
Turn off the unit before leaving.
4. This product is not a toy. Keep it out
of reach of children.
e.use this product in accordance
with these instructions, taking into
account the working conditions
and the work to be performed. Use
of this product for operations different
from those intended could result in a
hazardous situation.
5. People with pacemakers should
consult their physician(s) before use.
Electromagnetic fields in close prox-
imity to heart pacemaker could cause
pacemaker interference or pacemak-
er failure. In addition, people with
pacemakers should:
SKU 98319
For technical questions, please call 1-800-444-3353.
Page 3
• Avoid operating alone.
• Properly maintain and inspect to
avoid electrical shock.
OpERATING INSTRuCTIONS
Read the ENTIRE IMpORTANT
SAFETY INFORMATION
6. The warnings, precautions, and in-
structions discussed in this instruction
manual cannot cover all possible con-
ditions and situations that may occur.
It must be understood by the operator
that common sense and caution are
factors which cannot be built into this
product, but must be supplied by the
operator.
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information
regarding the parts listed in the following
pages, refer to the Assembly Diagram near
the end of this manual.
product Features
SpECIFICATIONS
Product
Appli-
cations
Designed to provide back-up power for radio,
LED lights, alarm, and mobile phone charging
functions.
FIGuRE A
Power
Dynamo Charger
Source
3.6VDC 120mAh Lithium Battery
Light
Source
3 Light Emitting Diodes (LED’S)
DC COVER
(17)
Radio
Run Time Time
1 Minute Crank Time = 5-10 Minutes Radio Run
1 Minute Crank Time = 3 LED’s for More Than 30
(CHARGER
Light On
Duration
Minutes.
JACK
INSIDE)
FREQuENCY
SWITCH
(15)
1 Minute Crank Time = 1 LED for More Than
1-1/2 Hours.
Mobile
Phone
Power
Duration
3
1 Minute Crank Time = 2-8 Minutes Talk Time /
40-50 Minutes Standby.
ALARM
AM
LED’S
1
LED
Alarm
Loudness
97 dB @ 12 Inches
FM
OFF
Accesso- Mobile Phone Charger Cord and Adapter
ries
(3.5mm O.D. / 1.1mm I.D.)
VOLuME
CONTROL
(14)
uNpACKING
When unpacking, check to make sure
MOBILE pHONE
CHARGER CORD
(28)
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
MOBILE pHONE
CHARGER CORD
ADApTER (29)
SKU 98319
For technical questions, please call 1-800-444-3353.
Page 4
1. Check to make sure the Switch But-
ton (13) is in its “OFF” position.
(See Figure A.)
• Charge the internal Battery (27) for
one minute by rotating the Crank
Handle (3). Then turn the Switch
Button (13) to its “3 LED” position.
All three LED Lights on the unit
will illuminate for approximately 30
minutes before recharging is neces-
sary. (See Figure A.)
2. To charge the internal Battery (27),
pull out the Crank Handle (3) and ro-
tate the Handle clockwise at a steady
rate for approximately one minute.
Then place the Crank Handle back in
its original position. (See Figure B.)
5. To operate the Alarm on the unit,
simple turn the Switch Button (13) to
its “ALARM” function.
CRANK HANDLE
(3)
(See Figure A.)
FIGuRE B
6. To charge a mobile phone, using the
Emergency Crank Radio/Flashlight:
• Charge the internal Battery (27) for
one minute by rotating the Crank
Handle (3). Then open the DC
Cover (17). (See Figure A.)
• Plug one end of the Mobile Phone
Charger Cord (28) into the Charging
Jack on the unit. Plug the other end
of the Charger Cord into the mobile
phone you wish to charge.
3. The Emergency Crank Radio/Flash-
light features AM and FM frequen-
cies.
• Charge the internal Battery (27) for
one minute by rotating the Crank
Handle (3). Then turn the Switch
Button (13) to either its “AM” or
“FM” function. (See Figure A.)
(See Figure A.)
• NOTE: One minute of crank time
on the Crank Handle (3) will allow
for 2 to 8 minutes mobile phone talk
time or 40-50 minutes standby.
• Turn the Frequency Switch (15) to
the correct “AM” or “FM” frequency
to select the desired radio station.
(See Figure A.)
7. When finished using the Emergency
Crank Radio/Flashlight, make sure
to turn the Switch Button (13) to its
“OFF” position. Then store the unit
in a clean, dry, safe location out of
reach of children and other unauthor-
ized persons.
4. The Emergency Crank Radio/Flash-
light features two LED Light func-
tions:
• Charge the internal Battery (27) for
one minute by rotating the Crank
Handle (3). Then turn the Switch
Button (13) to its “1 LED” posi-
tion. One LED Light on the unit will
illuminate for approximately 1-1/2
hours before recharging is neces-
sary. (See Figure A.)
SKU 98319
For technical questions, please call 1-800-444-3353.
Page 5
detergent. Do not use solvents. Do
not immerse the unit in liquid.
MAINTENANCE AND
SERVICING
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
pLEASE READ THE
FOLLOWING CAREFuLLY
THE MANUFACTURER AND/OR DISTRIBUTOR
HAS PROVIDED THE PARTS LIST AND
TO pREVENT
pOSSIBLE INJuRY
ASSEMBLy DIAgRAM IN THIS MANUAL AS
A REFERENCE TOOL ONLy. NEITHER THE
MANUFACTURER OR DISTRIBUTOR MAKES
ANy REPRESENTATION OR WARRANTy OF
ANy KIND TO THE BUyER THAT HE OR SHE
IS qUALIFIED TO MAKE ANy REPAIRS TO THE
PRODUCT, OR THAT HE OR SHE IS qUALIFIED
TO REPLACE ANy PARTS OF THE PRODUCT.
IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR ExPRESSLy STATES THAT
ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN By CERTIFIED
AND LICENSED TECHNICIANS, AND NOT By
THE BUyER. THE BUyER ASSUMES ALL RISK
AND LIABILITy ARISINg OUT OF HIS OR HER
REPAIRS TO THE ORIgINAL PRODUCT OR
REPLACEMENT PARTS THERETO, OR ARISINg
OUT OF HIS OR HER INSTALLATION OF
FROM ACCIDENTAL
OpERATION:
Turn the Switch Button (13) of
the Emergency Crank Radio/
Flashlight to its “OFF”
position before performing
any inspection, maintenance,
or cleaning procedures.
TO pREVENT pOSSIBLE
INJuRY FROM pRODuCT
FAILuRE:
Do not use a damaged
product. If abnormal noise or
vibration, or Battery leakage
occurs, have the problem
corrected before further use.
REPLACEMENT PARTS THERETO.
Inspection, Maintenance, and
Cleaning
1. BEFORE EACH USE, inspect the
general condition of the Emergency
Crank Radio/Flashlight. Check for
loose screws, cracked or broken
parts, damaged electrical wiring, bat-
tery leakage, and any other condition
that may affect its safe operation.
2. NOTE: Only a qualified service
technician should attempt to replace
the Rechargeable Battery (27) in this
unit.
3. AFTER USE, clean external surfaces
of the tool with clean cloth and mild
SKU 98319
For technical questions, please call 1-800-444-3353.
Page 6
pARTS LIST & ASSEMBLY DIAGRAM
part #
1
Description
Qty.
part #
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
Description
Qty.
1
Lower Housing
1
Frequency Switch
2
Upper Housing
Crank Handle
Handle Sleeve
Handle
1
Motor Assembly
1
3
1
DC Cover
1
4
1
Radio Board
1
5
1
Speaker Cover
1
6
Pin
1
Speaker
1
7
Rotary Wheel
Lens
1
Tap Screw (ST2x10)
Tap Screw (PW-ST2x8)
Tap Screw (ST2x5)
Tap Screw (ST2 x8)
Tap Screw (ST3x8)
Tap Screw (ST1.6x4)
Rechargeable Battery
Mobile Phone Charger Cord
4
8
1
1
9
Reflector
1
3
10
11
12
13
14
Head Cover
LED Board
Charging Socket Board
Switch Button
Volume Switch
1
4
1
1
1
2
2
1
1
1
Mobile Phone Charger
Adapter
1
SKU 98319
For technical questions, please call 1-800-444-3353.
Page 7
LIMITED 90 DAY WARRANTY
Harbor Freight Tools Co. makes every effort to assure that its products meet high
quality and durability standards, and warrants to the original purchaser that this prod-
uct is free from defects in materials and workmanship for the period of 90 days from
the date of purchase. This warranty does not apply to damage due directly or indirectly,
to misuse, abuse, negligence or accidents, repairs or alterations outside our facilities,
criminal activity, improper installation, normal wear and tear, or to lack of maintenance.
We shall in no event be liable for death, injuries to persons or property, or for incidental,
contingent, special or consequential damages arising from the use of our product. Some
states do not allow the exclusion or limitation of incidental or consequential damages, so
the above limitation of exclusion may not apply to you. THIS WARRANTy IS ExPRESS-
Ly IN LIEU OF ALL OTHER WARRANTIES, ExPRESS OR IMPLIED, INCLUDINg THE
WARRANTIES OF MERCHANTABILITy AND FITNESS.
To take advantage of this warranty, the product or part must be returned to us with
transportation charges prepaid. Proof of purchase date and an explanation of the com-
plaint must accompany the merchandise. If our inspection verifies the defect, we will ei-
ther repair or replace the product at our election or we may elect to refund the purchase
price if we cannot readily and quickly provide you with a replacement. We will return re-
paired products at our expense, but if we determine there is no defect, or that the defect
resulted from causes not within the scope of our warranty, then you must bear the cost
of returning the product.
This warranty gives you specific legal rights and you may also have other rights
which vary from state to state.
3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • (800) 444-3353
Record product’s Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only, and are not avail-
able individually as replacement parts.
SKU 98319
For technical questions, please call 1-800-444-3353.
Page 8
|